Pages

Sunday, September 13, 2009

Keepsake Box

While I was surfing on the Internet I found the following Keepsake box. I liked the closing system of this box and also found it quite simple to create a similar one. I did not want to make an exact copy of the original one, I wanted a bit higher one and to decorate the top with some carving.

Creating the dovetail sliding seemed very easy on the video, but I do not have a router table, so I had to figure out something else. Firstly I wanted to create this by cutting out the dovetail hole with a saw and clean out it wit chisels, but soon I realized that I didn't have enough manual skill to make it perfectly flat to allow the other part sliding smoothly in it. So I decided to make the top from 3 parts and glue them together. It also took a while to plane the parts of the top in the exact angle to fit well, but it was much easier and flattering than using chisels.

When I was ready with the top and the bottom, I created the corners and the remaining part of the dovetail from a different type of wood to have some pattern of the materials.

Finally I carved a small flower pattern to the top of the box and finished with varnish. With the carving on the top of the box has the following looking:

Keepsake box


One more shot from a different angle:




Finally an opened view: